Main Battery: Notes

WARNING: This page is about a different variant/trim than selected.

REMOVAL

WARNING:

To protect the hands from battery acid, a suitable pair of heavy duty rubber gloves should be worn when removing or servicing a battery. Safety glasses also should be worn.

WARNING:

Remove metallic jewelry to avoid injury by accidental arcing of battery current.

Position the driver seat fully forward and fully raised.
Remove the rear heat floor duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
Remove the Intelligent Battery Sensor (IBS). Refer to SENSOR, INTELLIGENT BATTERY (IBS), REMOVAL AND INSTALLATION .

Remove the negative battery cable(s). Refer to 5.7L, BATTERY DISCONNECT AND CONNECT .

Courtesy of CHRYSLER GROUP, LLC

1 - Positive Battery Cable End Nut

2 - Battery Vent Tube

3 - Battery

Loosen the positive battery cable end nut and remove the positive battery cable.
Remove the battery vent tube.

Courtesy of CHRYSLER GROUP, LLC

1 - Battery Hold-Down Nuts

2 - Battery Hold-Down
Remove the nuts from the battery hold-down. Remove the battery hold-down that secures the battery to the tray.

Courtesy of CHRYSLER GROUP, LLC

1 - Battery
Remove the battery from the vehicle.

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle.

During installation, torque the fasteners to the specifications in the torque table(s) below.

TORQUE SPECIFICATIONS