When Monitored

This diagnostic runs continuously when the following conditions are met:

• Shifter is in the DRIVE or REVERSE position.
• Transmission oil temperature is greater than a calibrated value.
• No clutch slip control functions commanded.
• No Input Speed Sensor signal Diagnostic Trouble Code (DTC)s set.
• Input Speed Sensor signal is greater than a calibrated value.
• Output Speed Sensor signal is valid or the output speed can be calculated from the wheel speed Controller Area Network (CAN) signal if the Output Speed Sensor signal is not available.
• Engine speed signal via CAN or output speed signal is greater than a calibrated value.
• During a gear shift:
  • The output speed and the output speed gradient must be greater than a calibrated value.
• When a gear is engaged:
  • The absolute value of the input speed gradient and pedal position must be less than their respective calibrated values.