LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2022 >> Gladiator Mojave, Part Time T/Case Control, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (3.0L Diesel - DTCS P2266-00 To P2457-00) >> DTC Troubleshooting >> P241D-00-SCR Inducement - Forced Engine Shutdown >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.
  1. READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN 
    1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
    2. For future reference, run and save a vehicle Scan Report and all related recorded data.
    3. With the scan tool, erase all DTCs.
    4. Turn the ignition off for a minimum of 75.0 seconds.
    5. Turn the ignition on.
    6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
    7. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

      • Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
  2. CHECK FOR OTHER DTCS 
    1. Refer to recorded DTCs.

      Along with P241D, are or more of the following DTCs active or pending?: P05EE-00, P05F1-00, P05F2-00, P05F3-00, P1220-00, P203A-00, P203F-00, P2047-00, P208A-00, P208B-00, P20E8-00, P20E9-00, P20FA-00, P2200-00, P220A-00, P220B-00, P229E-00, P242D-00, P2BA9-00, U029D-00, and/or U029E-00.

      Yes 

      • Perform the Diagnostics for those DTC(s) at this time.
scientia non olet · About LEMON Manuals