Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
2. For future reference, run and save a vehicle Scan Report and all related recorded data.
3. With the scan tool, erase all DTCs.
4. Turn the ignition off for a minimum of 10.0 seconds.
5. Turn the ignition on.
6. Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
7. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
REPAIR THE OIL VISCOSITY ISSUE AND RESET THE OIL CHANGE INDICATOR
1. Turn the ignition off.
2. Change the engine oil and filter in accordance with the Service Information.
3. Perform the RESET OIL CHANGE INDICATOR Procedure in ENGINE OIL REPLACEMENT REMINDER .
4. Perform the POWERTRAIN VERIFICATION TEST. Refer to 3.0L, POWERTRAIN VERIFICATION TEST .
5. With the scan tool, erase the Powertrain Control Module (PCM) DTCs.
6. Cycle the ignition.
  Did the oil change Indicator Light reset?
  
  Yes
  - Test Complete
  No
  - Perform the RESET OIL CHANGE INDICATOR Procedure in ENGINE OIL REPLACEMENT REMINDER .