LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Grand Cherokee L Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (5.7L - Battery System (Service Information)) >> Standard Procedure >> Battery Disconnect And Connect

Battery Disconnect And Connect

WARNING: This page is about a different variant/trim than selected.

DISCONNECT 

  1. Remove the rear heat floor duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
    GC0201072Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the Intelligent Battery Sensor (IBS) wire harness connector (2).
  3. Remove the ground terminal nut (3) and isolate the auxiliary battery cable (4) and set aside.
  4. Press and release the negative cable (1).

CONNECT 

GC0201072Courtesy of CHRYSLER GROUP, LLC
  1. Press the negative cable onto the IBS stud.
  2. Install the auxiliary ground wire (4) and tighten the nut (3) to the proper torque specification. Refer to TORQUE SPECIFICATIONS  .
  3. Connect the IBS wire harness connector.
  4. Install the rear heat floor duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals