LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Vehicle Theft Security (Service Information)) >> Antenna, Sentry Key >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0157668Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove both the upper and lower shrouds from the steering column, but do not remove the steering column from the vehicle. Refer to SHROUD, STEERING COLUMN, REMOVAL .
  3. Disengage the retainers (1) that secure the perimeter of the Sentry Key antenna (2) to the ignition lock cylinder housing.
  4. Disconnect the steering column wire harness connector (3) from the antenna connector receptacle.
  5. Remove the Sentry Key antenna from the ignition lock cylinder housing.
scientia non olet · About LEMON Manuals