LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Vehicle Theft Security (Service Information)) >> Antenna, Sentry Key >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

GC0157668Courtesy of CHRYSLER GROUP, LLC
  1. Position the Sentry Key antenna (2) close enough to the ignition lock cylinder housing to access and connect the steering column wire harness connector (3) to the antenna connector receptacle.
  2. Position the antenna over the end of the ignition lock cylinder and engage the retainers (1) that secure the antenna to the lock cylinder housing.
  3. Install the upper and lower shrouds onto the steering column. Refer to SHROUD, STEERING COLUMN, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals