Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Install the transmission oil cooler (1b) and secure the retainers (1a).
- Remove the seal and plug from the transmission cooler and the transmission cooler lines.
- Using NEW
gasket seals, install the transmission cooler lines (1b) to the transmission cooler (1c) and secure the retaining clips (1a).
- Install the radiator air deflector (1c) and secure the side retainers (1b). Securely tighten the bolts (1a).
- Install the front bumper reinforcement (1c). Tighten the bolts (1a) and the nuts (1b) to the proper specification. Refer to TECHNICAL SPECIFICATIONS
.
- Install the air cleaner inlet tube (1b) and securely tighten the nut (1a).
- Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Check transmission fluid level and correct as necessary. Refer to FLUID AND FILTER, STANDARD PROCEDURE .