LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (2.4L Cooling System) >> Transmission >> Cooler, Transmission Oil >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0164335Courtesy of CHRYSLER GROUP, LLC
  1. Install the transmission oil cooler (1b) and secure the retainers (1a).
    GC0165395Courtesy of CHRYSLER GROUP, LLC
  2. Remove the seal plugs from the transmission cooler and the transmission cooler lines.
  3. Using NEW  gasket seals, install the transmission cooler lines (1b) to the transmission cooler (1c) and secure the retaining clips (1a).
    GC0164958Courtesy of CHRYSLER GROUP, LLC
  4. Install the radiator air deflector (1c) and secure the side retainers (1b). Securely tighten the bolts (1a).
    GC0164821Courtesy of CHRYSLER GROUP, LLC
  5. Install the front bumper reinforcement (1c). Tighten the bolts (1a) and the nuts (1b) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0163589Courtesy of CHRYSLER GROUP, LLC
  6. Install the air cleaner inlet tube (1b) and securely tighten the nut (1a).
  7. Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
  8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  9. Check transmission fluid level and correct as necessary. Refer to FLUID AND FILTER, STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals