LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (2.4L Cooling System) >> Accessory Drive >> Pulley, Idler >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0171594Courtesy of CHRYSLER GROUP, LLC
  1. Install the idler pulley (3) and tighten the bolt to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0153811Courtesy of CHRYSLER GROUP, LLC
  2. Install the accessory drive belt (5) by positioning the belt over all of the pulleys with the exception of the tensioner pulley (7).
  3. Rotate the center bolt of the tensioner pulley (7) counterclockwise, install the accessory drive belt (5) on the tensioner pulley (7) and slowly release the tensioner.
  4. Visually inspect the belt to pulley alignment.
  5. Start the engine and allow to run at idle momentarily. Shut the engine off and reinspect the belt alignment.
  6. Install the right front tire and wheel assembly. Refer to INSTALLATION .
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals