LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1320 (Rear Suspension) >> Hub And Bearing >> Removal And Installation >> 4X2 >> Installation

Removal And Installation: 4X2: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0179863Courtesy of CHRYSLER GROUP, LLC
  1. Position the hub and bearing (1) to the knuckle.
    GC0179465Courtesy of CHRYSLER GROUP, LLC
  2. Install the closeout flange (2) and the hub and bearing bolts (1).
  3. Tighten the hub and bearing to knuckle bolts to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Install the rear brake rotor. Refer to ROTOR, BRAKE, REAR, INSTALLATION .
    GC0190257Courtesy of CHRYSLER GROUP, LLC
  5. Install the wheel speed sensor to the knuckle. Install and tighten the wheel speed sensor to knuckle bolt (1) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  6. Install the tire and wheel assembly. Refer to INSTALLATION .
  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals