LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1318 (Lamps/Lighting - Exterior (Service Information)) >> Lamp, Backup >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the lamp is not damaged.
  2. Position the lamp, then install and securely tighten the fasteners.
  3. Install the rear fascia. Refer to FASCIA, REAR, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals