LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1305 (Starting System (Service Information)) >> Starter >> Removal And Installation >> 2.4L >> Removal

Removal And Installation: 2.4L: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Left Hand Drive (LHD) shown, Right Hand Drive (RHD) similar.

  1. Remove the battery and battery tray

    Refer to TRAY, BATTERY, REMOVAL .

  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  4. If equipped with Front Wheel Drive (FWD), remove the intermediate shaft. Refer to FRONT, REMOVAL AND INSTALLATION and REAR, REMOVAL AND INSTALLATION .
  5. If equipped with All Wheel Drive (AWD), remove the Power Transfer Unit (PTU). Refer to REMOVAL AND INSTALLATION .
    GC0172700Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the wire harness connector (2) from the starter motor.
  7. Remove the B+ electrical connection nut (1) and disconnect the B+ electrical connection from the starter.
  8. Remove the lower starter bolt (3).
    GC0172633Courtesy of CHRYSLER GROUP, LLC
  9. Remove the upper starter bolt (1).
  10. Remove the gear selector cable retaining bracket bolt (2), then position the bracket (2) aside.
  11. Remove the starter motor.
scientia non olet · About LEMON Manuals