LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1305 (Starting System (Service Information)) >> Starter >> Removal And Installation >> 1.3L >> Installation

Removal And Installation: 1.3L: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0189274Courtesy of CHRYSLER GROUP, LLC
  1. Position the starter motor (1b), then install and tighten the lower starter bolt (1a) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0208207Courtesy of CHRYSLER GROUP, LLC
  2. Connect the starter motor wire harness connector (2).
  3. Connect the B+ electrical connection to starter motor (1b), then install and securely tighten the nut (3).
  4. Install B+ wire harness protective cover (1a).
  5. If 4X4/AWD equipped, install the axle shaft. Refer to FRONT, REMOVAL AND INSTALLATION and REAR, REMOVAL AND INSTALLATION .
  6. Install the splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
  7. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  8. Remove the support and lower the vehicle.
    GC0190298Courtesy of CHRYSLER GROUP, LLC
  9. Position the wire harness bracket (1b) and install the upper mounting bolt (1a) for the starter and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  10. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
  11. Install the battery tray. Refer to TRAY, BATTERY, INSTALLATION .
scientia non olet · About LEMON Manuals