LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Pump, Fluid >> Removal And Installation >> Oil Pump Installation

Oil Pump Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the intermediate support plate and oil pump with suitable solvent and blow them dry with regulated 344 kPa (50 psi) shop air.
  2. Inspect the intermediate support plate and oil pump for apparent damage or wear. If the intermediate support plate is damaged, the transmission will require replacement. If the oil pump is damaged, replace the oil pump.
    GC0159339Courtesy of CHRYSLER GROUP, LLC
  3. Insert the oil pump (1) into the intermediate support plate (2). Align the tabs on the pump with the notches on the intermediate support plate.
    GC0160004Courtesy of CHRYSLER GROUP, LLC
  4. Using a suitable pliers (1), compress the oil pump snap ring.
    GC0169598Courtesy of CHRYSLER GROUP, LLC
  5. While holding compression on the snap-ring (2), use (special tool #2016200211, Remover-Installer, 948 TE Transmission Pump) (1) with a C-clamp to compress the spring on the bottom of the oil pump just enough to seat the snap-ring (2).
    GC0159762Courtesy of CHRYSLER GROUP, LLC
  6. Install the oil pump drive chain (3) onto the oil pump driven sprocket (2).
    GC0159969Courtesy of CHRYSLER GROUP, LLC
  7. Install the oil pump drive sprocket (1) onto the drive chain (2).
  8. While holding the chain on the drive sprocket (1), turn the intermediate support plate and oil pump over on the work surface.
    GC0159645Courtesy of CHRYSLER GROUP, LLC
  9. Place the intermediate support plate and oil pump (1) in position on the bellhousing (3).
  10. Insert the oil pump drive sprocket into the oil pump sprocket needle bearing.
    GC0160151Courtesy of CHRYSLER GROUP, LLC
  11. Install the bolts (3) to hold the intermediate support plate and oil pump (1) to the bellhousing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
    GC0159236Courtesy of CHRYSLER GROUP, LLC
  12. Place the reaction shaft (2) into the intermediate support plate (3).
    GC0160151Courtesy of CHRYSLER GROUP, LLC
  13. Install the bolts (2) to hold the reaction shaft (1) to the intermediate support plate (4) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
    GC0177032Courtesy of CHRYSLER GROUP, LLC
  14. Insert the oil filter neck (3) into the oil pump bore and align the bolt hole with the tapped hole in the intermediate support plate (2).
    GC0159978Courtesy of CHRYSLER GROUP, LLC
  15. Install the bolt (2) to hold the oil filter (1) to the intermediate support plate and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
    GC0160105Courtesy of CHRYSLER GROUP, LLC
  16. Replace the O-ring seals (2) on the fluid tube (1).
  17. Install the fluid tube (1) into the bellhousing and intermediate support plate.
  18. Install the bellhousing on the transmission. Refer to BELLHOUSING, REMOVAL AND INSTALLATION .
  19. Install the transmission in the vehicle. Refer to REMOVAL AND INSTALLATION .
  20. Road test the vehicle to verify the repair.
scientia non olet · About LEMON Manuals