LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Harness, Internal Wire >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the internal transmission wire harness onto on the valve body.
  2. Install the solenoid wire harness connector fasteners and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
  3. Connect the wire harness connector to the transmission fluid pressure transducer.
  4. Install the valve body. Refer to VALVE BODY, REMOVAL AND INSTALLATION .
  5. Perform Transmission Verification Test-948TE. Refer to TRANSMISSION VERIFICATION TEST - 948TE 9HP48 .
scientia non olet · About LEMON Manuals