LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1303 (948TE Automatic Transmission (Service Information)) >> Cable, Shift >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the shifter cable and plate assembly through the opening in the floor pan.
  2. Install the shifter cable grommet and plate assembly nuts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
    GC0189430Courtesy of CHRYSLER GROUP, LLC
  3. Install the exhaust heat shield (1).
  4. Install the rear exhaust muffler. Refer to MUFFLER, EXHAUST, REMOVAL AND INSTALLATION, 1.3L or MUFFLER, EXHAUST, REMOVAL AND INSTALLATION, 2.4L .
    GC0179244Courtesy of CHRYSLER GROUP, LLC
  5. Attach the shifter cable (1) to the clip on top of the transmission.
    GC0178791Courtesy of CHRYSLER GROUP, LLC
  6. Attach the shifter cable (1) to the shifter cable bracket.
    GC0176794Courtesy of CHRYSLER GROUP, LLC
  7. Connect the shifter cable end (1) to the transmission manual lever.
    GC0189097Courtesy of CHRYSLER GROUP, LLC
  8. Insert the shifter cable through the gear shifter and attach the shifter cable retention clip (2).
    GC0189595Courtesy of CHRYSLER GROUP, LLC
  9. Install the shifter cable adjustment clip (1).
  10. Install the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
  11. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector first before connecting the negative battery cable.
  12. Verify shifter cable adjustment. Refer to CABLE, SHIFT, ADJUSTMENTS .
scientia non olet · About LEMON Manuals