Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Install a NEW
seal (1) in the port in the transmission housing.
- Install a NEW gasket (1) on the sealing surface of the transmission housing (2).
- If necessary, replace the output seal and the impeller hub seal.
- Guide the bellhousing (1) downward over the input and output shafts and onto the transmission housing (2).
- Rotate the output gear clockwise to assure guide pin (1) alignment.
- Rotate the output gear support (1) through the window (2) behind the valve body until the guide pin engages the receptacle hole in the bellhousing.
- Engage the guide pins in the transmission housing into the receptacle holes in the bellhousing to assure proper alignment.
- Install several bolts to hold the bell housing to the transmission housing. Tighten the bolts hand tight.
- Position the transmission on the bench with the bellhousing facing outward.
- Install the fasteners (1) with NEW
seal washers to hold the bellhousing to the output gear support and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the fasteners (1) to hold the bellhousing to the transmission housing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install NEW O-rings on both ends of the fluid transfer tubes.
- Install the fluid adapter tubes (1) in the transmission housing.
- Place the valve body with the internal harness near the transmission.
- Insert the speed sensors (1) into the transmission with the wire harness connected.
- Install the speed sensor fastener (1) to hold the speed sensors to the transmission housing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Place the TRS (1) in position on the transmission with the wire harness connected.
- Install the TRS fastener (1) to hold the TRS to the transmission housing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Align the valve body with the fluid transfer tubes.
- Guide the manual lever cam (1) into the slot (2) on the manual valve.
- Firmly press the valve body inward until the O-rings on the fluid transfer adapters engage into receptacle holes on the valve body.
- Install the valve body fasteners (1) to hold the valve body to the transmission housing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install a NEW
gasket seal (1) in the groove around the sealing surface of the valve body cover pan (2).
- Install NEW
O-ring seals (2) on the transmission solenoid connector (1).NOTE:
A light coating of assembly lube can be applied to the O-ring seals (2) of the transmission solenoid connector to ease installation.
- Place the valve body cover pan (1) in position on the transmission.NOTE:
Be certain that the flat side (2) on the transmission solenoid connector (3) is aligned with the flat spot (2) on the valve body cover pan (1).
- Insert the transmission solenoid connector (3) into the opening on the inside of valve body cover pan (1).
- Press the transmission solenoid connector outward until the retainer clip groove (1) is exposed on the outside of the valve body cover pan.
- Install the clip (2) to hold the transmission solenoid connector in the valve body cover pan.
- Install the valve body cover pan and valve body cover pan bolts (1) onto the transmission housing and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS .
- Install the transmission. Refer to REMOVAL AND INSTALLATION .