LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1292 (1.3L Exhaust System) >> Pipe, Exhaust >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the exhaust pipe with front flex pipe and connect it to the front muffler.
    GC0189795Courtesy of CHRYSLER GROUP, LLC
  2. Position the front suspension crossmember, install the left and right mounting bolts (1) and tighten it to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0190169Courtesy of CHRYSLER GROUP, LLC
  3. Install the front suspension crossmember bolts (1) and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Remove the hydraulic lift.
    GC0189434Courtesy of CHRYSLER GROUP, LLC
  5. Install the rear engine mount to transmission bracket bolt (1) and tighten it to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0189709Courtesy of CHRYSLER GROUP, LLC
  6. Install a NEW  gasket and the exhaust pipe to the catalytic converter. Tighten the NEW  nuts (1) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0190205Courtesy of CHRYSLER GROUP, LLC
  7. Install the front exhaust pipe support bracket bolts (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0190207Courtesy of CHRYSLER GROUP, LLC
  8. Install the exhaust pipe clamp bolt (2) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  9. Install the exhaust pipe rear bracket bolts (1) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  10. Install the right and left stabilizer bar nuts and tighten to the proper specification. Refer to FRONT, TECHNICAL SPECIFICATIONS .
    GC0188928Courtesy of CHRYSLER GROUP, LLC
  11. Install the right and left lower load beams (1a) and tighten the bolts (1b) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  12. Install the right and left reinforcement brackets and tighten the bolts (2) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0190310Courtesy of CHRYSLER GROUP, LLC
  13. Install the pedestrian impact crossmember and tighten the bolts (1) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0189018Courtesy of CHRYSLER GROUP, LLC
  14. Install the steering column, a NEW  bolt and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  15. Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
  16. Install the engine belly pan. Refer to BELLY PAN, INSTALLATION .
  17. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals