LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1287 (Frame And Bumpers) >> Bumpers >> Reinforcement, Bumper, Front >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0208240Courtesy of CHRYSLER GROUP, LLC
  1. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL  .
  2. Working on the lower left side of the bumper, disconnect the wire harness connector (1a) for the radar (1b).
  3. Release the retainer (2a) for the wiring (2b).
    GC0208239Courtesy of CHRYSLER GROUP, LLC
  4. Remove the bolts (1a) and the nuts (1b) and remove the bumper (1c).
scientia non olet · About LEMON Manuals