Removal And Installation: Removal
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable.
- Remove the tail lamps. Refer to LAMP, TAIL, REMOVAL .
- Raise and support the vehicle
Refer to HOISTING, STANDARD PROCEDURE .
- Remove the screws (1) at the bottom of the rear fascia.
- Using a trim stick or equivalent, release the clips (1a) and remove the rear wheel moldings (1b).
- Remove the screws (2a and 2b) from both sides of the rear fascia.
- Remove the screws (1a and 1b).
- Remove the rear fascia (2).