LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (2.4L Engine (Service Information)) >> Valve Timing >> TENSIONER, Engine Timing >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disengage the pawl (1a) from the rack, compress the piston (1b) and insert the pin lock (1c).
    GC0165061Courtesy of CHRYSLER GROUP, LLC
  2. Install the tensioner (1) and tighten the screws to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Remove the locking plunger pin (2).
  4. Install the timing belt. Refer to CHAIN AND SPROCKETS, TIMING, REMOVAL AND INSTALLATION  .
  5. Install the water pump pulley. Refer to PUMP, WATER, REMOVAL AND INSTALLATION .
  6. Install the crank pulley. Refer to DAMPER, VIBRATION, REMOVAL AND INSTALLATION  .
  7. Install the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL AND INSTALLATION .
  8. Install the air cleaner assembly. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION  .
  9. Install the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL AND INSTALLATION  .
  10. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION  .
  11. Install the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
  12. Install the right front wheel and splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
GC0163736Courtesy of CHRYSLER GROUP, LLC
scientia non olet · About LEMON Manuals