LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (2.4L Engine (Service Information)) >> Lubrication >> Pan, Oil >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0164304Courtesy of CHRYSLER GROUP, LLC
  1. Apply a 2 mm bead of Mopar® Engine Sealant RTV Silicone Rubber Adhesive around the oil pan as shown.
    GC0165103Courtesy of CHRYSLER GROUP, LLC
  2. Install the oil pan and tighten the bolts (1) to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Install the A/C compressor mounting bracket and tighten the bolts (2) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
    GC0162987Courtesy of CHRYSLER GROUP, LLC
  4. Position the lower load beam reinforcement bracket (1) back into place and tighten the bolts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
    GC0163103Courtesy of CHRYSLER GROUP, LLC
  5. Install the bolts (1) securing the front fascia to the front bumper and securely tighten.
  6. Install the oil filter and fill the engine crankcase with the proper oil to the correct level. Refer to FILTER, ENGINE OIL, REMOVAL AND INSTALLATION  .
  7. Install the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
  8. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  9. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  10. Remove support and lower the vehicle.
scientia non olet · About LEMON Manuals