LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1286 (2.4L Engine (Service Information)) >> Engine Block >> Damper, Vibration >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0164247Courtesy of CHRYSLER GROUP, LLC
  1. Install the vibration damper onto the crankshaft (1c).
  2. Using the (special tool #9707, Holder, Vibration Damper) (1a), Install the vibration damper bolt (1b) and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  3. Install the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL AND INSTALLATION .
  4. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  5. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  6. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals