Installation - Intermediate Fuel Delivery Line - 2.4L
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Position the intermediate fuel delivery and vapor lines to the vehicle and insert them into the front retaining clip.
- Close the front retaining clip (3) and connect the quick couplings (1) for the intermediate fuel delivery and vapor lines.
- Insert the intermediate fuel delivery and vapor lines (1 and 2) in the rear retaining clip.
- Position the front and rear fuel line shields and install the bolts (1). Tighten the bolts securely.
- Connect the quick couplings (1 and 2) for the right end of the front fuel delivery and vapor lines. Insert the lines into the upper and lower retaining clips.
- Insert the A/C suction and liquid lines into the retainers (1).
- Connect the clean air hose (2) to the throttle body and tighten the clamp (2) securely.
- Connect the wire harness connector (1) to the inlet air temperature sensor.
- Connect the clean air hose (3) to the air cleaner body cover and tighten the clamp (3) securely.
- Connect the engine oil vapor hose quick coupling (2).
- Install the bolt (1) for the clean air hose which goes between the air cleaner body cover and the throttle body.
- Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
- Install the side belly pan. Refer to BELLY PAN, SIDE, INSTALLATION .
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove the support and lower the vehicle.