Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
- CHECK FOR AN ACTIVE DTC
- Ignition on, engine not running.
- With the scan tool, read DTCs and record on the repair order.
Is the DTC active or pending?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT DTC .
- CHECK FOR OTHER DTCS
- Refer to the recorded DTCs.
Are there any Fuel Quantity, Fuel Rail Pressure, EGR, or Intake Air related DTCs active or pending?
Yes
- Perform the applicable diagnostic procedure(s). Refer to DIAGNOSTIC CODE INDEX .
No
- Go To 3
- Refer to the recorded DTCs.
- CHECK FOR A LEAKING FUEL INJECTOR NOTE:
Performing the (scan tool) Injector Quantity Correction test will isolate a leaking Injector.
- Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. Refer to CHECKING THE FUEL DELIVERY SYSTEM
.
Do any Injectors indicate a problem?
Yes
- Replace the Fuel Injector in accordance with the service information. Refer to INJECTOR(S), FUEL, REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to PCM VERIFICATION TEST .
No
- Go To 4
- Perform the CHECKING THE FUEL DELIVERY SYSTEM diagnostic procedure. Refer to CHECKING THE FUEL DELIVERY SYSTEM
.
- CHECK THE INTAKE AIR SYSTEM
- Perform the INTAKE AIR SYSTEM PRESSURE TEST diagnostic procedure. Refer to INTAKE AIR SYSTEM LEAK DETECTION
.
Were any Intake Air System problems found?
Yes
- Repair as necessary in accordance with the Service Information.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to PCM VERIFICATION TEST .
No
- Go To 5
- Perform the INTAKE AIR SYSTEM PRESSURE TEST diagnostic procedure. Refer to INTAKE AIR SYSTEM LEAK DETECTION
.
- CHECK RELATED HARNESS CONNECTIONS
- Disconnect all PCM harness connectors.
- Disconnect all related in-line harness connections (if equipped).
- Disconnect the related component harness connectors.
- Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
- Proper connector installation.
- Damaged connector locks.
- Corrosion.
- Other signs of water intrusion.
- Weather seal damage (if equipped).
- Bent terminals.
- Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
- Terminals that have been pushed back into the connector cavity.
- Check for spread terminals and verify proper terminal tension.
Repair any conditions that are found.
- Connect all PCM harness connectors. Be certain that all harness connectors are fully seated and the connector locks are fully engaged.
- Connect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
- Connect all related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
- With the scan tool, erase DTCs.
- Test drive or operate the vehicle in accordance with the when monitored and set conditions.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Replace and program the Powertrain Control Module (PCM) in accordance with the Service Information. Refer to MODULE, POWERTRAIN CONTROL (PCM), REMOVAL .
- Perform the POWERTRAIN VERIFICATION TEST. Refer to PCM VERIFICATION TEST .
No
- Repair the poor connections.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to PCM VERIFICATION TEST .