LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (6.2L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the flexplate or flywheel. Refer to FLEXPLATE, REMOVAL .
  3. Remove the oil pan. Refer to PAN, OIL, REMOVAL .
    GC0170149Courtesy of CHRYSLER GROUP, LLC
  4. Using the sequence shown in the illustration, remove the rear oil seal retainer mounting bolts.
  5. Remove and discard the rear oil seal retainer.
scientia non olet · About LEMON Manuals