LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (6.2L Engine (Service Information)) >> Lubrication >> Pan, Oil >> Removal

Pan, Oil: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    GC0180901Courtesy of CHRYSLER GROUP, LLC
  3. Drain the engine oil (1) and remove the oil filter (2).
  4. Remove the steering gear. Refer to GEAR, REMOVAL .
    GC0170168Courtesy of CHRYSLER GROUP, LLC
  5. Remove the engine oil tube fastener (1) from the exhaust manifold.
  6. Remove the engine oil dipstick and tube (2) from the oil pan.
    GC0180928Courtesy of CHRYSLER GROUP, LLC
  7. Disconnect the transmission cooling tubes from the oil pan (1).
    GC0180941Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Do not pry on the oil pan or oil pan gasket. The oil pan gasket is integral to the engine windage tray and does not come out with the oil pan.

    NOTE:

    The horizontal M10 retaining bolts (11, 12, 15, 18) are 5 mm longer in length then the vertical M10 retaining bolts (20, 21, 22, 23) and must be reinstalled in their original locations.

  8. Remove the M10 retaining bolts (horizontal 11, 12, 15, 18 and vertical 20, 21, 22, 23) from the rear of the oil pan to the transmission.
  9. Remove the M6 retaining bolts and remove the oil pan.
    NOTE:

    When the oil pan is removed, a new oil pan gasket and the integral windage tray assembly must be installed, the old gasket cannot be reused.

  10. Remove the oil pump pickup tube retaining bolt and nut.
  11. Remove the oil pump pickup tube.
  12. Remove and discard the oil pan gasket/windage tray.
scientia non olet · About LEMON Manuals