Cover(S), Cylinder Head: Removal: Left
WARNING: This page is about a different variant/trim than selected.
- Disconnect and isolate the negative battery cable.
- Remove the air cleaner body and makeup air hose. Refer to BODY, AIR CLEANER, REMOVAL .
- Remove the ignition coils. Refer to COIL, IGNITION, REMOVAL .
- Remove the fuel injector and ignition coil wire harness from the valve cover and position aside.
- Using the sequence shown in the illustration in the illustration, remove the cylinder head cover retaining bolts.
- Remove the cylinder head cover (1).
- Clean the sealing surface of the cylinder head (2).
NOTE:
The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.