Cover(S), Cylinder Head: Installation: Left
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.
CAUTION:
Do not allow other components including the wire harness to rest on or against the engine cylinder head cover. Prolonged contact with other objects may wear a hole in the cylinder head cover.
NOTE:
The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.
- Clean the cylinder head cover (1) and the sealing surface of the cylinder head (2). Inspect the cylinder head cover gasket and the coil tower gaskets, replace if necessary.
- Install the cylinder head cover and hand start all fasteners.
- Using the sequence shown in the illustration in the illustration, tighten the cylinder head cover bolts to 11 N.m (97 lbs in.).
- Install the ignition coils. Refer to COIL, IGNITION, INSTALLATION .
- Install the fuel injector and ignition coil wire harness.
- Install the power steering pump reservoir (Refer to 19 - Steering/Pump/RESERVOIR, Power Steering Pump/Installation).
- Install the air cleaner body and fresh air makeup hose. Refer to BODY, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable.
- Start the engine and inspect for leaks.