Body, Air Cleaner: Installation
WARNING: This page is about a different variant/trim than selected.
- If removed, insert the air inlet tube onto the air cleaner housing and tighten the clamp to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- While sliding the air duct onto the throttle body, lower the air cleaner housing into position, while aligning the air cleaner housing grommets (1) on bottom of the housing.
- Position the air inlet tube retaining clamp (1) at the throttle body and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
- Connect the make-up air hose (2) to the air inlet tube.
- Connect the Inlet Air Temperature (IAT) sensor wire harness connector (3).
- Verify that the air cleaner housing (4) is properly secured to the grommets.
- Connect the negative battery cable.