LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (5.7L Engine (Service Information)) >> Engine Block >> Retainer, Crankshaft Rear Oil Seal >> Removal

Retainer, Crankshaft Rear Oil Seal: Removal

WARNING: This page is about a different variant/trim than selected.
GC0081773Courtesy of CHRYSLER GROUP, LLC
NOTE:

The crankshaft rear oil seal is integral to the crankshaft rear oil seal retainer and must be replaced as an assembly.

NOTE:

The crankshaft rear oil seal retainer can not be reused after removal.

NOTE:

This procedure can be performed in vehicle.

  1. Disconnect the negative battery cable.
  2. Remove the transmission. Refer to appropriate service information.
  3. Remove the flexplate. Refer to FLEXPLATE, REMOVAL .
  4. Remove the oil pan. Refer to PAN, OIL, REMOVAL .
  5. Using the sequence shown in the illustration, remove the rear oil seal retainer mounting bolts.
  6. Carefully remove the retainer from the engine block.
scientia non olet · About LEMON Manuals