Removal - Right Cylinder Head
WARNING: This page is about a different variant/trim than selected.
- Remove the oil fill cap (1).
- Remove the engine cover (2).
- Perform the fuel pressure release procedure. Refer to STANDARD PROCEDURE .
- Disconnect and isolate the negative battery cable (2).
- Remove the cowl cover panel (2). Refer to COVER, COWL PANEL, REMOVAL .
- Drain the cooling system. Refer to STANDARD PROCEDURE .
- Remove the air cleaner and resonator assembly. Refer to BODY, AIR CLEANER, REMOVAL .
- Remove the cylinder head cover. Refer to COVER(S), CYLINDER HEAD, REMOVAL .
- Remove the engine oil indicator tube retaining nut at the exhaust manifold and remove the oil indicator tube.
- Remove the intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL .NOTE:
The rocker arms and push rods must be installed in their original location as removed.
- Remove the rocker arms and push rods. Note their location to ensure installation in their original locations. Refer to ROCKER ARM, VALVE, REMOVAL .
- Using the sequence shown in the illustration, remove the cylinder head bolts.
- Remove the cylinder head and discard the cylinder head gasket.