LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Mp3023 Transfer Case (Service Information)) >> Seal, Output Shaft, Rear >> Removal

Seal, Output Shaft, Rear: Removal

WARNING: This page is about a different variant/trim than selected.
GC0146287Courtesy of CHRYSLER GROUP, LLC
  1. Remove the rear propeller shaft. Refer to SHAFT, DRIVE, REAR, REMOVAL .
  2. Using Holder (special tool #C-3281, Holder, Flange) (1), remove the rear companion flange (2) nut.
    GC0146288Courtesy of CHRYSLER GROUP, LLC
  3. Remove the rear output shaft flange from the output shaft. If necessary, use a suitable 2 or 3 jaw puller to remove the output shaft flange.
    GC0146295Courtesy of CHRYSLER GROUP, LLC
  4. Remove the rear output shaft seal with a suitable pry tool or a screw mounted in a slide hammer.
  5. Remove the rear cover bolts and the rear cover from the transfer case.
scientia non olet · About LEMON Manuals