Shaft, Drive, Rear: Removal

CAUTION:

Propeller shaft removal is a two-person operation. Never allow propeller shaft to hang from the center bearing, or while only connected to the transmission or rear axle flanges. A helper is required. If a propeller shaft section is hung unsupported, damage may occur to the shaft, coupler, and center bearing from over-angulation. This may result in driveline vibrations or component failure.

Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
If equipped, remove the skid plates. Refer to PLATE, SKID, FRONT SUSPENSION .
Remove the exhaust (1). Refer to the appropriate service information MUFFLER, EXHAUST, REMOVAL .
CAUTION:
Failure to follow these instructions may result in a driveline vibration.
Mark the propeller shaft to the pinion flange and transmission/transfer case flanges for installation reference.

Courtesy of CHRYSLER GROUP, LLC
Remove the heat shield (3) from the center bearing.

Courtesy of CHRYSLER GROUP, LLC
Remove the center support bearing bracket (1).
Remove the propeller shaft from axle pinion flange.
Remove the propeller shaft from transmission/transfer case flange.
With the aid of a helper, remove propeller shaft assembly.