LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2018 >> Grand Cherokee Laredo, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (3.0L Turbo Diesel (Service Information)) >> Cylinder Head >> Camshaft, Engine >> Removal >> Right Camshafts

Right Camshafts

WARNING: This page is about a different variant/trim than selected.
GC0146592Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the right timing chain and sprocket. Refer to CHAIN AND SPROCKETS, TIMING, REMOVAL .
  3. Remove the bolts and the right (special tool #VM.10343A-1, Alignment Tool, Cylinder Head (Right Intake)) (1).
  4. Check the camshafts end play using the  (special tool #C-3339A, Set, Dial Indicator). End play should be between 0.1 mm - 0.3 mm (0.003 in. - 0.011 in.). If the camshaft endplay is not within specification, replace the cylinder head. 
    GC0146587Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Make a reference in the order the camshaft bearing caps were removed.

  5. Remove the bolts (3) and the intake and exhaust camshaft bearing caps (2).
  6. Remove the right side intake and exhaust camshaft (1).
scientia non olet · About LEMON Manuals