LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Power Seats (Service Information)) >> Switch, Seat >> Installation

Switch, Seat: Installation

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0144604Courtesy of CHRYSLER GROUP, LLC
  1. Connect the electrical connector (3) to the power seat switch (1). Make sure the connector is fully engaged to the switch.
  2. Position the power seat switch to the seat cushion side trim panel (5) and engage the four retaining tabs (2 and 4) that secure the switch to the trim panel. Make sure the retaining tabs are fully engaged.
  3. Install the outboard seat cushion side trim panel. Refer to SIDE SHIELDS, SEAT, POWER, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals