Side Shields, Seat, Power: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Disable the airbag system before attempting any component diagnosis or service of the front seats, when equipped with front seat air bags. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.
- If necessary, connect the wire harness connectors to the seat switches.
- Position the side shields onto the seat and install the screws.
- Install the screw covers.
- Install the front seat. Refer to SEAT, REAR, INSTALLATION .