LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Wiper System & Washer System (Service Information)) >> Nozzle, Washer >> Installation >> Rear

Nozzle, Washer: Installation: Rear

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0159954Courtesy of CHRYSLER GROUP, LLC
  1. Position the rear washer nozzle (4) to the mounting hole in the liftgate spoiler (1). Be certain that the rubber gasket is in position on the back of the nozzle bezel or flange.
  2. Using hand pressure, push firmly and evenly on the nozzle bezel or flange until both integral latch features (3) are fully engaged on the inside of the spoiler mounting hole.
  3. Connect the washer supply line quick-connect fitting (2) to the quick-connect barbed nipple on the back of the nozzle.
  4. Engage the washer hose into the routing clips on the back of the Center High Mounted Stop Lamp (CHMSL) housing (5).
  5. Install the spoiler onto the liftgate outer panel. Refer to SPOILER, INSTALLATION .
scientia non olet · About LEMON Manuals