Nozzle, Washer: Installation: Headlamp
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Take proper precautions to ensure there is no cosmetic damage done to the paint finish of the headlamp washer nozzle cover or the front fascia during the following procedure.
- Insert the quick-connect nipple and body of the headlamp washer nozzle (3) into the mounting hole of the front fascia (1).
- Engage the fixed mounting clip (4) on the nozzle body through the mounting hole. Then tilt the nozzle body rearward far enough to engage the movable mounting clip (2) through the mounting hole and until the nozzle bezel is flush with the surface of the front fascia.
- From the back side of the front fascia (1), reconnect the high pressure hose quick-connect fitting to the quick-connect nipple of the headlamp washer nozzle.
- Install the front fascia onto the vehicle. Refer to FASCIA, FRONT, INSTALLATION .