Fascia, Front: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- With the help of an assistant, position the fascia to the vehicle.
- Align and hand tap the fascia sides (3, 6) to engage the fascia retaining tabs. Repeat on the opposite side.
- Install the eight push pin fasteners (2) from the upper fascia closeout panel (1).
- Install the four fascia to upper radiator support push pins (1).
- Install the fascia bracket fasteners (1) and (2).
- Position the upper radiator closeout panel (1) back into place and install the push pin fasteners.
- Raise the vehicle.
- Install the fender to fascia fastener (1). Tighten the fastener securely. Repeat for the opposite side.
- Connect all necessary electrical connectors.
- Position the fascia lower closeout panel (1), install the thirteen fasteners (2) securing the fascia lower close out panel. Tighten the fasteners securely.
- Install the front splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
- Lower the vehicle.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.