LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Wiper System & Washer System (Service Information)) >> Motor, Wiper >> Installation >> Rear

Motor, Wiper: Installation: Rear

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new rubber grommet into the liftgate glass. Always use a new grommet in the glass.
  2. Install the rear wiper motor through the grommet in the liftgate glass.
    GC0159895Courtesy of CHRYSLER GROUP, LLC
  3. Install the three screws (3) that secure the motor. Tighten the screws securely.
  4. Connect the wire harness connector (4).
  5. Install the liftgate trim panel. Refer to PANEL, TRIM, INSTALLATION .
  6. Install the rear wiper arm. Refer to ARM, WIPER, INSTALLATION .
  7. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals