Panel, Trim: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the trim panel (2) back onto the liftgate (1) and Using hand pressure, press firmly and evenly on the trim panel over each of the retaining clip locations until the clips are seated fully in the holes on the inside of the liftgate.
- Install the pull cups (1).
- Secure the trim panel (2) to the inside of the liftgate.
- Position the trim panel (1) back onto the liftgate (2) and Using hand pressure, press firmly and evenly on the upper trim panel over each of the fastener locations until the fasteners are fully seated in the holes on the inside of the liftgate.
- Position the top liftgate trim (2) onto the liftgate and seat the upper retaining clips fully.