LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 67 (Wiper System & Washer System (Service Information)) >> Linkage, Wiper Arm >> Removal

Linkage, Wiper Arm: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove both front wiper arms. Refer to ARM, WIPER, REMOVAL .
  3. Remove the cowl cover panel from over the front wiper module. Refer to COVER, COWL PANEL, REMOVAL .
    GC0160134Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connector (2) from the front wiper motor.
  5. Remove the two screws at the ends, from the bracket (3 and 5).
  6. Pull the front wiper module (1) inboard far enough to disengage the rubber isolator from the slotted bracket (4).
  7. Remove the front wiper module from the cowl plenum.
scientia non olet · About LEMON Manuals