Sensor, Fuel Tank Pressure: Removal
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the fuel filler cap to relieve tank pressure.
- Partially raise the vehicle.
- Remove the right rear wheel house splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL
.
- Disconnect the fuel tank pressure sensor harness connector (1).
- Carefully raise the retaining tab (2), rotate and remove the fuel tank pressure sensor (1) from the fuel tank vent tube.
- The fuel tank pressure sensor seal (1) can be reused if not damaged.