Front Outboard
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The park assist sensors (1) and the O-ring spacers (2) are each available for separate service replacement. The sensor brackets (3) are bonded to and integral to the inside surface of the bumper fascia (4).
NOTE:
In vehicles equipped with the optional Parallel and Perpendicular Park Assist (PPPA) option only, the park assist sensors located in the outward facing ends of both the front and rear bumper fascias are unique and must not be interchanged with any other forward or rearward facing park assist sensor.
- Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
- Remove the fasteners that secure the front of the front fender wheel house splash shield to the front bumper fascia, the front belly pan and the front end structure. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
- Pull the splash shield back from the front bumper fascia far enough to access and disconnect the wire harness connector from the park assist sensor (1) connector receptacle.
- Carefully pry the sensor bracket (3) latch features away from the latch tabs of the sensor far enough to disengage the sensor from the bracket.
- Disengage the O-ring spacer (2) from around the circumference of the sensor membrane protrusion.