LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System) >> Engine >> Pump, Water >> Removal >> 2.4L

Pump, Water: Removal: 2.4L

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right front wheel house splash shield Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .

    .

  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  3. Drain the coolant. Refer to STANDARD PROCEDURE .
  4. Remove the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL .
    GC0098471Courtesy of CHRYSLER GROUP, LLC
  5. Remove the three bolts (1) and the water pump pulley (2).
  6. Remove the bolts (3) the water pump (4) and the water pump gasket (8).
  7. Inspect the water pump housing (6) for impeller contact.
scientia non olet · About LEMON Manuals