LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Sahara, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Engine Cooling System) >> Engine >> Pump, Water >> Installation >> 2.4L

Pump, Water: Installation: 2.4L

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0098471Courtesy of CHRYSLER GROUP, LLC
  1. Clean the gasket mating surface.
  2. Using a NEW  gasket (8), install the water pump (4) and tighten the bolts (3) to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  3. Install the water pump pulley (2) and tighten the bolts (1) to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
  4. Install the serpentine belt Refer to BELT, SERPENTINE, INSTALLATION .

    .

  5. Install the belly pan Refer to BELLY PAN, INSTALLATION .

    .

  6. Install the right front wheel house splash shield Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .

    .

  7. Perform the Air Evacuation and Coolant Fill Procedure. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals