Sensor, Manifold Air Pressure (Map): Installation: 2.4L
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect and replace the O-ring seal (1) as necessary.
- Install Manifold Absolute Pressure (MAP) sensor (1) and rotate 90° clockwise to lock in place.
- Connect the MAP sensor wire harness connector (2).
- Install the belly pan Refer to BELLY PAN, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.