Sensor, Air Temperature, Inlet: Installation
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- If necessary, inspect and replace the O-ring seal (1).
- Install the Intake Air Temperature (IAT) sensor (3) and rotate 1/4 turn clockwise to lock in place.
- Install the air cleaner resonator (1). Refer to RESONATOR, AIR CLEANER, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.